CKD floating joint FJ-0-18 Japan CKD floating joint WFK3012S (sensor type voltage output specifications: -A0, -A2, -A3 alarm setting use the sensor upper rotary switch. The setting of the rotary switch should be done with a precision screwdriver, etc. If too much force is applied to the rotating part, there may be poor contact with the contact point, please pay full attention. The set value of the flow is fixed, as shown in the right table. If you need to change the value, please negotiate separately. The function description divides the alarm output flow into 10 levels. Divides the alarm output flow into 10 levels. OUT 1: wire (black) OUT 2: wire (orange) corresponding. Display the state of the alarm output. Display the state of the alarm output. Display the instantaneous flow. 10 / min below decimal display 10 / min above integer display discharge within the specification range, the light is on. When the power is turned on, the light is on. When wiring, please be sure to refer to the precautions for use. The connector uses the VA connector (model: TM-4DSX3HG4) produced by Corens company Specifications: DC use, 4-core 0.5mm 2 options (analog output, alarm output form) unsigned; (0-5 [V], NPN-P; (0-5 [V], PNP)
Floating joint FJ-0-18 belongs to the Fluid Control Components series under CKD company, model number FJ-0-18. To purchase or inquire about Floating joint FJ-0-18, you can directly contact 158 0047 0089 (Mr. He).
1. Cylinders: Used to convert the energy of compressed air into mechanical energy to produce linear motion.
2. Pneumatic valves: Used to control the direction, speed, and pressure of airflow, regulating the operation of pneumatic systems.
3. Pneumatic motors: Devices that convert compressed air into rotary motion.
4. Air tubes and connectors: Used to connect various components in pneumatic systems and transmit air.
Yes, CKD pneumatic components require regular maintenance to ensure normal operation and extend service life. Key maintenance points include:
- Regularly check and replace seals and gaskets to prevent air leakage.
- Inspect and clean filters to ensure clean air quality.
- Lubricate moving parts to reduce wear and improve efficiency.
- Check air tubes and connectors to ensure secure and undamaged connections.
When selecting the appropriate CKD pneumatic components, consider the following factors:
Application requirements: Understand the specific working environment and tasks, such as load, speed, and stroke.
Air source conditions: Ensure that the pressure and flow of the air source meet the component’s requirements.
Installation space: Confirm available space and choose components of suitable size.
Environmental factors: Consider the temperature, humidity, and potential corrosiveness of the working environment to select suitable materials and designs.
Common pneumatic system faults include:
Air leakage: Causes efficiency decline; check seals, connections, and tubes, find leak points, and repair or replace.
Stuck cylinder piston: Possibly caused by dirt or insufficient lubrication; clean the piston and add lubricant.
Valve failure: Check electrical control signals, ensure smooth airflow, and verify if the valve itself is damaged.
Insufficient pressure: Inspect air source pressure, filters, and piping to ensure no blockage or leakage.
